User manual in Original
Doc. ref: 500A_MB_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
We page: www.disperator.se
38 / 41
14. Insert a small click of special grease (P26) into the keyway of the carrier (P2) and push on the key
(P9).
15. Wipe clean the axle hole in the rotary shredder (P10). Also make sure that the mating surfaces
on the end shield (P3) and the stationary shredder (P13) are clean.
16. Carefully fit the rotary shredder (P10) on the carrier (P2).
17. Wipe the carrier (P2) clean from excess grease.
18. Apply a layer of rubber sealing compound (P27) over the joint between rotary shredder and
carrier (see photo below). Make sure that no sealing compound enters the screw hole of the
carrier.
19. Fit the axle washer (P11) on the rotary shredder.
Apply rubber
sealing compound
around the
underside of the entire head of the axle screw (P12) and mount this screw. Make sure that
sealing compound is squeezed out around the entire circumference of the axle washer, and also
around the entire head of the axle screw. For disposer models 510 and 515 the axle screw is
tightened with torque 9,3 Nm, and for model 520 the axle screw is tightened with torque 22 Nm,
and for models 530, 550 and 575 the axle screw is tightened with torque 44 Nm.
20. Apply a thin uninterrupted string of rubber sealing compound (P27) in the seat of the end shield
(P3)
in which the stationary shredder (P13) should be pressed down
. See below photo.
21. Carefully position the stationary shredder (P13) with its upper large tooth closest to the outlet of
the end shield (P3).
22. Tap around the top of the stationary shredder (P13) with a plastic hammer to fix it in the end
shield (P3), and make sure that the stationary shredder is all the way down in the seat of the end
shield.
23. Secure the stationary shredder (P13) to the end shield (P3) by hammering 6 punch marks on the
end shield with even distances around the joint between these two articles. See below photo.
24. Fit a new rubber seal (P14) on the top of the stationary shredder (P13). Make sure that it is
centered.
25. Wipe clean the surface of the hood (P15) that faces the rubber seal (P14).
26. Carefully fit the hood (P15). For the upper hole pattern of the hood to end up in the same way as
before dismantling, the outside arrow mark on the hood lower edge shall be positioned centrally
above the waste outlet on the end shield (P3).
This to make sure that the disposer outlet will
have the same direction towards the sewer connection as before. Also feel with your fingers that
the seal (P14) still is centered.
Summary of Contents for EXCELLENT 500A-MB Series
Page 2: ......
