User manual in Original
Doc. ref: 500A_GTS-E65_am_en_210608
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
34 / 48
9.4.2. Machine Starts but there is no Flushing Water
9.4. Trouble Shooting
9.4.1. Disposer Reduces Speed, Stops or does not Start
A humming sound might be heard from the disposer motor
1. Press the red stop button (0).
2. Use the main electrical safety breaker placed on the wall to disconnect electrical supply. Lock
the breaker with a padlock or a cable tie if you temporarily need to leave the machine before
step 11 below is completed.
3. Use protective gloves. Remove the protective cover above the disposer inlet by unscrewing
the star knob on the outside of the hopper, inside the cabinet. Check if something is jammed
in the disposer grinding unit.
4. If something is jammed, place the jam release wrench on the center washer.
The recess
on the lower plate of the wrench should grab one of the two bars on the disc, see picture
below.
5. Release the grinder by rotating the wrench backwards and forwards until the shredder
rotates freely a complete turn in both directions. If needed, extend the bar on the wrench
and hit the bar with a hammer.
6. Remove the jam release wrench.
7. Remove any non grindable object from the disposer, e.g. cutlery.
8. Remount the protective cover and fix it with the star knob. Make sure
that
the key on the cover slides into the interlock switch that closes it.
9. Check wall fuses / automatic breakers. Change/reset if needed.
10. Reset motor protectors by pressing in the two red buttons on the terminal box AS1 inside
the cabinet.
11. Connect the electrical supply on the main electrical safety breaker placed on the wall.
12. Press the green button (1) to start and empty the machine.
13. Press the red button (0) - the machine stops.
Grinder and jam release
wrench from above
1. Is the shut off valve in the water supply pipe open? If not, open this valve.
2. Is a clicking sound heard when activating the solenoid valve (starting the machine)? If not,
change the coil.
3. Is the line strainer clogged? Turn off water supply, open nut on strainer and clean. Close nut
on strainer carefully without damaging the seal, and make sure it is tight when the machine
is restarted.
4. Have timer relay settings been changed by mistake, or is timer out of order?
Open this nut in order to clean the line strainer
9.4.3. Machine does not Start and makes no Sound
1. Check that the protective cover in the inlet hopper is in place and properly closed.
2. Check that the main electrical safety breaker is in ON-position.
3. Make sure the wall fuses / automatic breakers are switched on.
4. Check that the two motor protectors for disposer and pump are reset by pressing in the two
red buttons on the terminal box AS1 inside the cabinet.
If the fault cannot be remedied, please contact authorized service personnel or Disperator AB /
local representative. Always provide the disposer’s serial number when contacting Disperator.
Summary of Contents for 500A-GTS-E65 EXCELLENT SERIES
Page 2: ......
