User manual in Original
Doc. ref: 500A_DRR-K_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
20 / 44
Below mentioned numbers in brackets refer to the position number in the image and the list on
the previous pages.
1. Measure, mark and drill two holes diameter 16,5 mm for the shaft of the lid, one hole on
each side of the sink/dishwashing line. Make sure that the protective lid (1) is centered
above the disposer inlet. See picture below for measurements.
Ø D
A
E
(with the lock bolt
on the left-hand
side)
E
(with the lock bolt
on the right-hand
side)
B
C
L
180
87,5
11,3
52
Width of
sink (out-
side)
B/2+25
B+32
238
119
2. Mount the rubber buffer (2) on the protective lid. Put the bushing (3), with the thread
outwards, on the shaft of the protective lid (1), one on each side of the lid, note that there
is a grease lubricated O-ring (4) in the bushings. Put the lid into the sink by slipping the axle
through the holes made in step 1 of this instruction. Put on the nuts (6) on the bushings and
tighten them by hand.
3. Make sure that the protective lid is centered above the disposer inlet. Make a mark on
the shaft, 25 mm outside of the side of the sink, to which the interlock assembly is to be
mounted, and 7 mm outside the sink on the other side. Remove the lid from the sink. Cut
the shaft at the marks you just made. Make sure that there are no sharp edges on the ends
of the shaft. Note, the O-ring in the bushings is damaged if the ends are poorly graded.
4. Put the O-rings (5) on the bushings and lubricate the inner O-rings (4) with a water-resistant
grease, put the bushings on the shaft of the protective lid, one on each side of the lid. Put
the lid into the sink. Put on the nuts (6) on the bushings and tighten them. Make sure that
the protective lid is closed and in the correct position
5. Fit the cable gland (8) and cable to the interlock switch (7). Loosen the four screws on the
top of the interlock switch and turn the top 90 degrees, depending on whether the lock bolt
should be on the left or right side
Summary of Contents for 500A-DRR-K EXCELLENT Series
Page 2: ......
