User manual in Original
Doc. ref: 500A_DRR-K_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: [email protected]
Mälarvägen 9, 141 71 Segeltorp
Web page: www.disperator.se
16 / 44
6. Installation Description for the Machine
6.1. Assembly of the Machine
6.1.1. Mounting the Disposer With a DRR-K Mounting
After a hole, diameter 170 mm, has been made in the sink / dishwasher line, an extension pipe
(not included in standard delivery) is welded on. The stainless steel assembly ring with an inner
diameter of 170 mm is then welded to the extension pipe, so that its position provides the
desired direction for the outlet of the disposer. The disposer is then screwed on to the assembly
ring.
6.1.2. Mounting and Support against Floor/Floor plate
Mounting of models 510 and 515, delivered without legs as standard
The weight of disposer models 510 and 515 allows them, in most cases, to be hung vertically
under the mounting assembly (e.g. under a sink). The standard delivery of these models
therefore does not include legs. However, if they are to be placed standing on the floor/floor
plate (e.g. beside a peeling machine/dishwasher) these models must be fitted with legs. If legs
have been ordered it is specified on the delivery note.
To minimize the risk of injuries, two persons shall always be present when the disposer is
installed. Below describe three different approaches, depending on the availability of tools at the
installation site.
Place the disposer tightly against the flange of the mounting assembly, by using one of below
mentioned hoist methods. Make sure that the disposer top rubber seal is correctly positioned.
Tighten the six screws with nuts evenly. The rubber seal should be compressed approximately
1 mm.
Hoist alternative 1
Trolley, see picture below.
Summary of Contents for 500A-DRR-K EXCELLENT Series
Page 2: ......
