Dish Network 167821, User Manual

Page: 18 / 40

8
P
ROGRAMMING THE
R
EMOTE TO
C
ONTROL A
S
ECOND
R
ECEIVER IN
AUX M
ODE
If you have another DISH Network satellite receiver installed, you can
use this remote in
AUX
mode to control it along with your new
receiver. When you program the remote to control the other receiver,
the remote sends out IR signals to the receiver. You can program the
remote to control any other DISH Network satellite receiver, except for
following:
• TV2 on Duo 322 (also known as DISH 322), DuoDVR™ 522,
DuoDVR™ 625, DuoDVR™ ViP
®
222, and DuoDVR™ ViP
®
622 (also known as DISH Player-DVR models 522, 625, and
ViP 222, & ViP 622 DVR)
• DishPlayer 7100/7200
1
Turn on the other receiver and display the System Info screen (see
the receiver’s
User Guide for information on how to display this
screen).
Write down the address shown:
2
Press and hold the
AUX
button until all the other mode buttons
light up, and then let go of the button. The AUX button flashes.
3
Press the
3
button.
4 Use the NUMBER PAD to enter the address you wrote in
step 1.
5 Press POUND (# ). The AUX button blinks three times.
6
Press
RECORD
to make sure the address and the remote matches
the address on the receiver.