Dish Network 167821, User Manual

Page: 14 / 40

4
P
ROGRAMMING
U
SING
E
QUIPMENT
C
ODE
T
ABLES
You can set up the remote to control other equipment using the
equipment codes listed on page 12 and the modes as shown on page 1.
Instructions Additional Information
1 Turn the equipment on. Use the equipment’s front panel
buttons or its remote control.
2 Find the brand name of the
equipment in the tables
starting on page 12.
If the brand isn’t listed, see
Scanning for Equipment Codes
on page 5.
3
Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
For example, hold the
TV
mode
button for a TV until all of the
other mode buttons light. When
you let go,
TV flashes.
4 For AUX mode only . Press
0 for a second TV, or 1 for a
second VCR, or 2 for a
tuner or amplifier.
This step is for programming
the kind of equipment that
should be programmed in
AUX
mode. If you’re not
programming in
AUX mode,
skip to step 5.
5 Enter one of the three-digit
equipment codes from the
table using the number
buttons.
The three-digit equipment code
should be for the brand name of
your equipment that you found
in step 2.
6 If you want to program
Limited Mode, press 1.
If not, skip to step 7.
See Limited Mode on page 3 for
more information.
7
Press
POUND (#).
If you entered the code
correctly, the mode button
flashes three times.
8 Press POWER to turn off
the equipment. If the
equipment does not turn
off, go to step 10.
If the code works, the
equipment turns off.