16
6
Use the
ARROW
buttons to move the highlight to the TV1
remote address (the
Rem Addr
box as shown below). This is
important—if you do not move the highlight, your remote control
will change the receiver's TV2 remote address (the
Rem
Addr
box) and cause your Remote Control 1 to control the TV2
side of your receiver.
7
Press the
RECORD
button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning appears, go to
step 12 of this procedure.
8
On the remote control, press and hold the
SAT
mode button for
about three seconds, until all the mode buttons light up, and then
release the
SAT
button. The
SAT
mode button will blink.
9
Use the number buttons to enter any number from 1 to 28,
except
for the address shown for
on your screen.
Write down the number you entered:
10
Press the
POUND
(
#
) button. If you entered the address correctly,
the
SAT
mode button will flash three times. Press
RECORD
on
the remote.
11
Make sure the
System Information
screen shows
UHF
and
that this address matches the number that you entered in step 9.
12
Select
Done
to close the
System Information
screen. If
nothing happens, press
RECORD
, and then select
Done
.
h
i
Device
Rem Addr
TV Ch Out
3
5
T
UHF
i
Note
: Highlight the
Rem Addr
(the lighter area in the
graphic above).