14
4
Press
POUND (#
). If you entered the address correctly, the
SAT
button will flash three times. Write down the number you entered
in the space provided on the inside back cover of this guide.
5
Press
RECORD
. Make sure the
Secondary Remote Address
you see on the
System Information
screen is the same as the
one you entered in step 3. If it isn't, the remote control cannot
operate the receiver. Press
RECORD
a second time.
6
Select
Done
to close the
System Information
screen.
Note
: This remote control may have features not used by your
receiver.
C
HANGING
B
ETWEEN
UHF
AND
IR U
SING
THE
UHF/IR
S
WITCH
Your remote has a switch to change the type of signaling that your
remote control uses. It comes preset to the
UHF
position, but if you
have a clear line of sight to your receiver, you can change the setting to
the
IR
position to eliminate the possibility of any other UHF remote
control interfering with yours.
1
Remove the battery cover from the remote control.
2
Use a small screw driver or a paper clip to carefully
change the setting.
3
Put the battery cover back on the remote control.
4
Use the
SYSTEM INFO
button on the front panel
to open the
System Information
screen.
5
Press
RECORD
on the remote control.
6
Make sure the remote address on the receiver’s
System Information
screen shows the correct
information:
•
Switch Position
UHF
—
IR/UHF
•
Switch Position
IR
—
IR only
All receiver models (
except
the ViP222, ViP222k,
ViP622 DVR, ViP722 DVR or ViP722k DVR
receivers) must use switch position
IR
or the remote
will not control the receiver.
