Tel: 0845 1238367 Fax: 01942 665104 e-mail: [email protected] web: www.discreteheat.co.uk
I N S TA L L AT I O N
2 . CUTTING SKIRTING TO LENGTH (when not supplied pre-cut)
Page 3
TM
0~3mm (0.0")
50mm (2")
DEBURR!
Keep parallel
Deburring tool
(Part No. STOOL)
100mm (4")
‘Bell Mouth’
deburr
20mm (0.8")
120mm (5")
!
Remove all chaff
and debris
40mm
20mm
TRV Feed/return
1x clip at back
1x clip at back
2x clips at front
2x clips at front
1x clip at front
1x clip at front, 1x clip behind
2x clips at front
1x clip at front (or back)
1x clip at front
COMMON CUTTING ALLOWANCES (note number and configuration of clips)
IMPORTANT - ALL CUT ENDS MUST BE DEBURRED AS SHOWN BELOW
IMPORTANT:
All cut ends MUST be deburred to preserve your warranty.
Remove all chaff and debris to preserve your warranty. Problems may occur
if not properly removed.
Internal corner
External corner
Return manifold
Odd angle - internal
Odd angle - external
In-line joint (> 6m walls)
Door architrave kit
Non TRV feed & return /
threshold kit
115mm (min)
Minimum active
length = 55mm (2.16")
Offer the flexible coupling up
centrally to the internal corner and
mark the wall at this point to give
the cut length of skirting
Push into corner
Avoid chafeing
on the corner
=
=
=
=
Offer flexible coupling up centrally
to the external corner and
mark the wall at this point to give
the cut length of skirting
