Installing Bluetooth Module
In our 2001 XJR test vehicle with Premium Audio, the Bluetooth module was
installed in armrest (See
Fig. 10
). In this area you will also find factory
phone plug (See
Fig. 11
) and cigar lighter, either of which can be used to
power module (see
Fig. 10
).
Fig. 10
Fig. 11
1.
Connect/Tap module
Red wire
to
12V Accessory supply
(Do not
connect to constant battery supply)
If vehicle has phone plug, use chart below to tap module accessory
wires
. Always test prior to making connection
.
Factory connector/Plug
Accessory wire
Ground wire
10-pin Female (white)
Pin 10
(light green)
Pin 6
(black)
10-pin Male (yellow)
Pin 10
(white/green)
Pin 6
(black)
14-pin (yellow)
Pin 13
(Green)
Pin 11
(black)
18-pin male (yellow)
Pin 5
(Green)
Pin 11
(black)
2.
If vehicle does not have a phone plug, use cigar lighter power lines
under console:
Tap module’s
Red
wire
to White/
Blue
= 12V ACC
Fig. 12
Note
: Cigar lighter power may introduce noise into the system. This is not the result of
a faulty module but vehicles electrical system. Find a clean power/ground supply (we
recommend factory phone plug). If engine noise is still an issue, consider adding this
or similar.
3.
Connect audio module 8-pin DIN plug routed from trunk (See
Fig. 4
) to
Bluetooth module female connector seen in
Fig. 13
