2.
Connect supplied 3.5mm audio cable (See
Fig. 3
) to module
“AUX” jack
(See
Fig. 4
). Route audio cable other end to dash area or wherever Aux
device will reside (within 3 ft.)
Fig. 3
Audio cable
Fig. 4
Module
3.
Secure visor microphone (See
Fig. 5
) to visor or headliner using included
visor clip (See
Fig. 6
)
Fig. 5
Microphone
Fig. 6
Visor clip
4.
Route microphone cable down pillar, under steering column and into
radio cavity.
5.
Connect microphone plug to M
odule “MIC”
input jack (See
Fig. 4
)
Be cautious not to damage or cut both microphone cable.
6.
Porsche CR-1 and CR-2 radios have two possible wiring configuarions
that varies based on vehicle (See
Fig. 7
). The A2DIY-CR12 module ships
with power harness seen in
Fig. 8
Module accessory wire (power) connection
:
- Radios with 8-pin
iso plugs
(See
Fig. 7
) proceed to step 7
- Radios
with 5-pin power plug proceed to step 9
5-pin plug
8-pin ISO plug
Fig. 7
Radio plugs
7.
CR-1/CR-2 radios with 8-pin ISO:
Disconnect factory 8-pin plug from radio and mate with to 8-pin
connector on power harness. (See
Fig. 8
)
8.
Connect power harness 8-pin plug (See
Fig. 8
) to radio 8-pin connector
vacated in step 7 (See
Fig.7
)
Fig. 8
Power harness
9.
CR-1/CR-2 radios with 5-pin plug (See Fig. 7):
Cut red wire from
power harness (See
Fig. 8
) and tap to ACC (
GREEN
) wire on 5-pin plug
seen in
Fig. 7
(color may vary but pin position remain the same)
10.
Discard power harness (See
Fig. 8
)
Proceed to “Pairing” section on page
6
