Elite Setup Guide- Thermal Printer
6
With the printer set up, follow these steps to allow final set-up:
Open the ACC (Autoloader Control Console) this will allow the printer to be aligned.
When the ACC is opened, click on Run Diagnostics and allow
the loader and printer to cycle. Once complete all the areas
should be green.
If any of the circles are RED, STOP DO NOT CONTINUE
until steps are taken to correct the issue
.
If all are GREEN then click on the Comm Center folder.
When the Comm Center folder is displayed, click on
Calibrate. The unit will run through a calibration and
stop.
Place CDRs or DVDRs into the input spindle and click
on Print from input. Watch very carefully and when the
CD pick up device places the CD onto the printer,
observe the alignment. Move the printer tray until the
CDR is placed onto the center of the print tray. Run
more test input cycles and observe how the unit
operates.
Once the printer and tray is aligned:
1) Tighten rear thumb screws
2) Carefully remove printer & tighten front thumb screw
3) Replace Printer
4) Now you are ready to print
(
If the alignment is not correct STOP and correct or you
may damaged media and possibly the PRINT HEAD)