Elite Setup Guide- Thermal Printer
3
Thermal Printer Option
Installation of the PowerPro CD Printer
Review the printer documentation included in the carton with the PowerPro printer. Install the thermal
ribbon and ready the printer for printing. Perform and complete any printer checks before installing
the printer onto the Elite unit.
Note to obtain additional supplies for the printer call toll free
1-888-800-4041 or online at
Discmarket.com
The Elite is generally supplied with an Inkjet Printer Tray and this tray must be removed. Please
store this tray if you plan to ever use the Elite for Inkjet printing.
To install the printer onto the Elite unit following these steps:
Install the thermal ribbon and prepare the PowerPro for operation
Install the PowerPro Software located on the CD supplied with the printer documentation.
Remove the Inkjet tray that was shipped on the Elite.
Locate and install the PowerPro Thermal Printer tray onto the Elite Unit
Secure the fasteners snug, but do not tighten.
Place the printer into the print holding tray located at the top of the drive stack. Holding the printer
with hands on the left and right side, insert the front of the printer at an angle first, and then let the
back section “drop into” place. The printer should be securely inserted into the print holder tray and
should be completely level.
Connect the parallel printer cable provided with the Elite into the rear of the printer and connect into
the Elite connector on the rear of the Elite (or to your PC if the you are using an external PC).
Connect the CD Printer mini din control cable to the rear of the Elite and connect the DB9M
connector into mating connector in the rear of the printer.
Connect the AC Power cord that was provided with the CD Printer next to the rear of the printer and
connect into a standard 115VAC outlet.
When you connect the printer and power is applied, the printer will perform a basic internal test and
then wait for additional commands from the operator or the software. Once the printer has completed
it self-tests, you will need to align the printer. First open the printer tray and open one of the drives
below the printer. Look down through the printer tray opening adjust the printer position so that the
center of the tray aligns with the drive tray center. Next close the printer and drive trays.