Dirty Hand Tools 100171, Operation Manual

Page: 8 / 28

8
Important Safety Information
REPAIR AND MAINTENANCE
55R55)5().5)*,.5."5&)!5-*&#..,51"(5#.5#-5#(5*)),5'"(#&5
condition or in need of repair. Frequently check that all nuts,
bolts, screws, hydraulic fittings and hose clamps are tight.
55R55)5().
alter the log splitter in any manner. Any alteration will
void the warranty and could cause the log splitter to be unsafe
to operate. Perform all recommended maintenance procedures
before using the log splitter. Replace all damaged or worn parts
immediately.
55R55)5().
tamper with the engine to run it at excessive speeds.
The maximum engine speed is preset by the manufacturer and is
XJUIJOTBGFUZMJNJUT4FF,PIMFSFOHJOFNBOVBM
55R5
Remove the spark plug wire before performing any service or
repair on the log splitter.
55R55&13-5"%5."5&0&5) 5"3,/&#5)#&5(5(!#(5)#&5 ),5
operation.
55R
Replacement parts must meet manufacturer’s specifications.
HYDRAULIC SAFETY
The hydraulic system of the log splitter requires careful inspection
BMPOHXJUIUIFNFDIBOJDBMQBSUT#FTVSFUPSFQMBDFGSBZFELJOLFE
cracked or otherwise damaged hydraulic hoses or hydraulic
components.
55R55"%5 ),5"3,/&#5ł/#5&%-5
by passing a piece of paper or
cardboard underneath or over the area of the leak.
)5().5"%5
),5&%-51#."53)/,5"(85
Fluid escaping from the smallest hole,
under pressure, can have enough force to penetrate the skin causing
serious injury or death.
55R55%5*,) --#)(&5'#&5..(.#)(5#''#.&35# 5#($/,
35-*#(!5"3,/&#5ł/# 4FSJPVTJOGFDUJPOPSSFBDUJPODBO
develop if medical treatment is not administered immediately.
55R55
Relieve all pressure by shutting off the engine and moving the
valve control handle back and forth should it become necessary to
loosen or remove any hydraulic fitting.
55R55)5().5
remove the cap from the hydraulic tank or reservoir while
the log splitter is running. The tank could contain hot oil under
pressure which could result in serious injury.
55R55)5().5
adjust the hydraulic valve. The pressure relief valve on
the log splitter is preset at the factory. Only a qualified service
technician should perform this adjustment.
!
WARNING