12
3 Before use
3
Before use
3.1
Unpacking
1.
Unpack the appliance and all its accessories.
2.
Check that the contents are intact (Fig. 1).
3.2
Selecting the proper nozzle
The furniture brush (Fig. 2/2a, 2b), the upholstery nozzle (Fig. 2/3) and
the crevice nozzle (Fig. 2/4) are included as
accessories
in the scope of
delivery besides the floor nozzle (Fig. 2/1).
-
Furniture brush (Fig. 2/2a, 2b):
Use this to vacuum dust off objects
that have sensitive surfaces. The head of the furniture brush can be
rotated through 360°. Adjust it according to requirements.
-
Upholstery nozzle (Fig. 2/3):
Use this to vacuum up dust off
upholstered furniture.
-
Crevice nozzle (Fig. 2/4):
Use this to vacuum dust from hard to
reach places.
*Optionally available
(i. e. included in the scope of delivery depending
on model and features) are also:
-
Parquet brush (Fig. 3/1*)
Its long bristles make it especially suitable for cleaning delicate
surfaces (e.g. parquet and laminate floors).
-
Turbo brush (Fig. 3/2*)
This has a rotating brush head and is most suitable for thoroughly
deep cleaning carpets. The brushing also raises the carpet pile.
-
Long flexible crevice nozzle (Fig. 3/3*)
Use this to vacuum dust from distant, hard-to-reach places.
3.3
Assembly
1.
Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2.
Insert the end of the suction hose into the intake opening (Fig. 5/A) of
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3.
Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4.
Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage.
Keep the packaging for such an event.
However, dispose of no longer needed packaging material properly.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1
4
2b
2a
3
2
1*
2*
3*
3
NOTE:
When you use the long, flexible crevice nozzle, under certain circum-
stances the pressure inside the vacuum cleaner might drop too far thus
triggering the safety valve. The signal for this is e.g. a whistling noise
(depending on the vacuum cleaner model) and greatly reduced suction
performance. In this case, depending on the vacuum cleaner model and
equipment, you have to reduce the suction power or open the bypass
vent until the valve no longer triggers.
A
1
B
1
4
A
B
C
5
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not con-
nected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
M7075.book Seite 12 Dienstag, 1. März 2011 11:27 11
