8
CAUTION
Only use the cylinder vacuum cleaner when all filters are intact,
dry and correctly fitted. Make sure that no objects obstruct the
telescopic tube, the suction hose or other openings.
4.1 OPERATIONAL SAFETY
IMPORTANT:
Risk of injury! Check machine and power cord before each use. A damaged machine must never be used.
IMPORTANT:
Take extra care when positioning and using the vacuum cleaner on the stairs
IMPORTANT:
The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner
off and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry
before putting back into the machine).
4.2 HOW TO USE
IMPORTANT:
When unwinding the power cord do not pull further than the yellow marker.
1. Pull out the cord by the
plug up to the yellow mark
(Fig. 5/1) and no further
than the red mark
(Fig. 5/2).
2. Plug into the mains.
3. Switch on the cylinder
vacuum cleaner with the
on/off switch (Fig. 5/4).
4. If using the combi tool, set
the "carpet/hard floor"
selector according
to the type of floor that is
to be cleaned (Fig. 6):
- Fig. 6/A: for deep- and
short-pile carpets, rugs.
- Fig. 6/B: for smooth
floors, e.g. parquet, tiles,
PVC, etc.
5. Open the air vent on the
handle to reduce the
suction if required.
IMPORTANT:
When leaving your working-area, switch off the appliance and comply with the notices in chapter 4.3,
"Switching off". This will help avoid accidents.
5
6
DD_Real Power M28_OUTPUT-RK.indd 8
26/03/2015 10:48
