page 24 of 56
D.O.TEC
®
ANDIAMO.AES (SRC) Hardware Guide - Version 1.0
DirectOut Technologies
®
CHAPTER 4: Operation
© 2013 DirectOut GmbH
The selection of the active MADI port depends on the set redundan-
cy mode of the device. See ‘Software Guide ANDIAMO Remote’.
Default setting at initial start ‘Standard’:
The MADI input that locks fi rst will be selected automatically.
Once the selected input looses its signal, the other input will be se-
lected as signal source, if an input signal is detected there.
Clocking continued - MAdi stAtE
Lock and sync states of the two MADI inputs are indicated indi-
vidually by two LEDs (SYNC MADI 1 / 2). If both MADI inputs are
connected the LED of the unselected input will glow or blink with a
reduced intensity (50%).
in 1
lEd (yellow): indicates the selection
state and lock/sync state of MAdi input 1
LED ON (100%) = MADI input is:
locked / in sync / selected
LED ON (50%) = MADI input is:
locked / in sync / not selected
LED blinking (100%) = MADI input is:
locked / not in sync / selected
LED blinking (50%) = MADI input is:
locked / not in sync / not selected
LED OFF = no MADI signal is detected
in 2
lEd (yellow): indicates the selection
state and lock/sync state of MAdi input 2
LED ON (100%) = MADI input is:
locked / in sync / selected
LED ON (50%) = MADI input is:
locked / in sync / not selected
LED blinking (100%) = MADI input is:
locked / not in sync / selected
LED blinking (50%) = MADI input is:
locked / not in sync / not selected
LED OFF = no MADI signal is detected
