14
403.NISS3HT 3.09 2009 Nissan Altima (Smart Key)
© 2020-08-12 Directed. All rights reserved.
Module programming
1
Wait
until the LED turns ON solid red.
Note:
To skip the transponder programming and use convenience features only,
press
the programming button 5 times. When the LED turns ON solid orange,
proceed
to
step 2.
Note
: If the LED flashes orange, the CAN BUS is active. Proceed with programming
and skip step 3.
2
Make sure
that every key fob except one is located a minimum of 10 feet (3 meters)
away from the vehicle BEFORE proceeding with the following programming sequence.
3
Press
the Unlock button on the OEM key fob. The LED flashes orange.
4
Insert
the OEM key fob into the key port. The LED will continue flashing orange.
5
Depending on the transmission of the vehicle:
Manual:
Press
and
hold
the clutch pedal until the LED starts flashing green for 3
seconds, then shuts OFF.
-
Automatic:
Press
and
hold
the brake pedal until the LED starts flashing green for 3
seconds, then shuts OFF.
-
The module is now programmed.
6
Troubleshooting:
If the LED continues flashing orange after 15 seconds at step 5,
press
and
hold
the
programming button until the LED starts flashing red. When you
release
the
programming button, the LED starts flashing orange again. Repeat step 5.
7
Remove
the OEM key fob from the key port.
You have successfully completed the module programming sequence.