Directed 933.MIT3, Installation Manual, Page: 18 / 23

18
933.MIT3 2.11.195.3 2012 Mitsubishi Lancer Evolution
©2022 VOXX•DEI LLC. All rights reserved.
External Module Synchronization
LED Description Troubleshooting
(Flashes red, red,
then orange) x 10
OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Active Ground When Running (Status)
LED Description Troubleshooting
Flashes green
Ground When Running (Status) command
received.
The module has initialized the remote start sequence.
Flashes red & orange
Ignition ON command received. The module has received the Ignition ON command and is processing the remote start sequence.
Flashes green quickly
Start ON command received. The module has received the Start ON command and is processing the remote start sequence.
Flashes red x 10
PTS shutdown error. The PTS output from the module was not activated due to safety protection.
Flashes red x 21
CAN bus incorrectly detected.
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring
reference charts)” to check the connections.
Commands
LED Description Troubleshooting
Flashes orange x 1
LOCK command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Flashes orange x 2
UNLOCK command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Flashes orange x 3
TRUNK command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Flashes orange x 4
AUX1 command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Flashes orange x 5
AUX2 command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Flashes orange x 6
AUX3 command received. If the bypass module fails to flash, it did not receive the signal. Commands can come from RF or D2D.
Shutdown Codes
LED Description Troubleshooting
Flashes green x 1
Takeover successful. Normal operation.
Flashes red x 1
Runsafe was not disabled.
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in
takeover mode.
Flashes red x 2
Brake was not detected. The brakes were not detected, which prevents the system from shutting down the vehicle.
Flashes red x 3
Smart key was not detected. The smart key was not detected, which prevents the system from shutting down the vehicle.
Flashes red x 4
Speed was detected. The vehicle was detected as moving, which prevents the system from shutting it down.