Directed Electronics ProSecurity SR6000, Installation Manual

Page: 28 / 57

2 28 8
sense wire shutting down the unit prematurely.
In addition, you must connect a tan (+) shut-down input to the yellow wire on the relay satellite ribbon cable.
This prevents the remote start system from activating if the key is left in the "run" position. If your remote start
system only has one tan input, you must use diodes to isolate the ignition circuit from the brake switch input.
However, due to future manufacturer changes in vehicles, it is possible that this may not apply to all vehicles.
In addition, color variations are possible from model to model; make sure to test the circuit carefully. Please call
Ungo Technical Support if you need assistance in making this interface.
IIM MP PO OR RTTA AN NTT!! Once the interface is complete, attempt to remote start the vehicle with the door
closed and the key in the ignition. The vehicle should not start. If it does, recheck the connec-
tions.
G Geen neerraall M Mo otto orrss ttrru ucckkss,, ssp po orrtt u uttiilliittyy vveeh hiicclleess aan nd d cco ollu um mn n ssh hiiffttiin ng g p paasssseen ng geerr vveeh hiicclleess::
P Prree--1 19 99 96 6 D Do od dg gee D Daakko ottaa p piicckku up pss w wiitth h 2 2..5 5 lliitteerr m mo otto orrss::