8
English
–
Mode
: Select the scan mode.
–
Advanced Setup
: If the camera is networked but
not scanned, use this setup. This setup allows you
to change the network setting of the NVR’s VIDEO
IN port which is camera’s network environment.
Check the camera’s network setting first before
you use this setup. Make sure that this setting
does not conflict with the WAN setting. For more
information on the WAN setting.
1
Select
Scan
to commence scanning.
2
Select a camera from the scan list and then select
Add
Camera
. The Device Login window will appear.
3
Enter a
User ID
and a
Password
for the selected
camera.
Camera View Buttons
●
ALIGNMENT
Button: Realigns camera screens
displayed on the video display area in the order of
Video
In
port connections.
●
RESET
Button: Refreshes the video display area and
the camera list.
●
TOOL
Button: Displays network camera tool window
and changes the camera protocol.
Camera List Area
Following options can be accessed by right-clicking on a
camera list entry:
●
Add/Remove Camera
: Adds or removes the selected
camera. The Add Camera option is inactive if the camera
has already been added to the screen.
●
Authentication
: Enter the necessary camera login info.
This option is inactive for DirectIP™ and IDIS cameras
because they do not require logins. This option is
inactive for IDIS protocol only if the password is set.
Video Display Area
Left-click on the video display area to toggle between split
screen and single screen modes.
Drag the camera screens around to rearrange them.
Apply/Cancel Buttons
While in Camera Registration mode, select
Apply
to register
all changes.
Select
Cancel
to exit Camera Registration mode without
applying the changes.
It is not possible to register a camera that has already
been registered to a different NVR.
Diagnosis Process
When the camera is registered to the NVR,
Self-diagnosis
runs automatically for the new registered and changed
cameras. If
Self-diagnosis
is processing,
Diagnosis
Processing
message will be displayed. If
Self-diagnosis
is
failed,
Diagnosis Requirement
message will be displayed.
In this case, you can run
Self-diagnosis
manually. For more
information, refer to the operation manual.
