Diono Radian 5, Instruction Manual

Page: 9 / 55

1. The cup can be fitted in four different positions on the arms of the car seat
marked by the grey tabs.
2. Slot the pin on the side of the cup into the hole on the fabric cover in front of the
grey tab. Push the pin down into the mounting point in the arm rest of the car
seat until it locks in place.
3. The cup can be removed and fitted in a new position by gripping the sides and
pulling upwards sharply.
15–25 kg harness shoulder pads
WARNING:
• For children who weigh 15-25 kg, please use the set of 15-25 kg harness
pads provided instead of the regular harness pads.
Fitting the regular harness pads for rear-facing birth to 15 kg and forward-
facing 9 to 15 kg
1. Unfasten the harness shoulder straps and pull them through the seats backrest
as shown on page 15. Refit after fitting the shoulder pads.
2. Feed the ends of the shoulder straps through the sleeves on the pads (Fig. 1).
Fitting 15–25 kg harness pads for forward-facing and rear-facing:
1. Unfasten the harness shoulder straps and pull them through the seat backrest as
shown on page 15.
2. Unfasten the hook and loop on the sleeves of the 15–25 kg harness pads, then
place the shoulder straps inside (Fig. 2).
3. Fold the sleeve back over and fasten to the back section (Fig. 3).
4. Feed the metal end on the shoulder strap through the same slot that the harness
shoulder strap goes through.
5. Then feed the metal end back through the next harness slot down (Fig. 4).
Note:
Place the child in the car seat, firmly pull the 15–25 kg harness pads along the
shoulder straps to ensure a snug fit.
WARNING:
• The detachable base MUST only be used when fitting the car seat in the
rear-facing position.
Before placing the car seat into the vehicle, ensure the detachable base is
correctly fitted following the instructions on page 10.
1. Place the car seat on the vehicle’s seat and push into the back of the vehicle’s
seat backrest
(Fig. 1) .
IMPORTANT:
Check that the base of the car seat is flat against the vehicle’s seat, and
the front of the car seat is firmly pressed against the vehicle’s seat backrest.
Note: It may be necessary to move the front seat of the vehicle slightly forwards to fit the
car seat. The car seat must not be pushed upwards by the vehicle’s seat once it is fitted.
2. Feed the vehicles seat belt through the belt path under the padded seat (Fig. 2).
3. Check the seat belt has not become twisted, then fasten by slotting the tongue
on the seat belt into the buckle on the vehicle’s seat (Fig. 3) .Fold the sleeve back
over and fasten to the back section (Fig. 3) .
4. Place your hand in the middle of the car seat and push down as hard as you can whilst
pulling all of the slack out of the diagonal belt of the vehicle’s seat belt (Fig. 4) .
5. Move the front seat backwards to make contact with radian 5. If the gap cannot
be closed or you are installing radian 5 in the front passenger seat, the rear-
facing bolster should be used.
6. Attach seat belt lock-off clip (see page 24 for installation instructions ).
Always ensure Radian 5 is supported by the seat back when installed rear-facing.
4
1
2
3
4
1
2 3
1 2
3 4
1 2 3
17 16
Fitting the cup holder
Rear-facing lap-shoulder seat belt installation
Birth – 25 kg (Groups 0+, 1, 2)