Fitting the bolster:
1.
The two plastic pins on the back of the rear-facing bolster need to be aligned
with the holes in the top of the back of the car seat’s backrest.
2.
When using the top tether strap, remove the strap from the storage
compartment on the top of the car seat's backrest. Slot the ends of the tether
strap through the hole in the middle of the bolster.
3.
Press the pins on the top of the bolster into the holes in the backrest, you will
know when they have been successfully inserted as they will lock in place with
a
“CLICK“
.
Removing the bolster:
Grip the sides of the rear-facing bolster and pull the bolster off the back of the car seat.
1
2
WARNING:
•
The use of top tether strap is recommended for all rear-facing
installations AND MUST BE used for occupant weighing 15 to 25 kg.
•
When fitting the car seat in the rear-facing position, attach the top
tether to an approved tether anchorage point.
•
NEVER attach the tether strap to any movable parts or mechanisms of
the vehicles seat.
If your vehicle does not have a tether anchorage point, consult the owner’s manual supplied
with your vehicle, the manufacturer or an authorised vehicle dealer for more information.
Using the top tether strap:
1.
Before you fit the car seat in your vehicle, remove the top tether strap from the
storage compartment on the top of the car seat's backrest
(Fig. 1)
.
2.
Pull the adequate webbing through the tether adjuster attached to the anchorage
strap on the back of the car seat while pressing the release button
(Fig. 2).
3.
Install the car seat in the vehicle in the rear-facing
(see page 17
) position and find
the tether attachment points, check in the vehicles owners manual
(Fig. 3).
4.
Fasten the clip on the end of the tether strap over the anchorage. Tighten the
tether strap by pulling the loose end of the tether strap until it becomes tight
and tension indicator turns green
(Fig. 4) (see page 20).
•
If vehicle does not have tether anchorage points, consult vehicle
owner’s manual or contact vehicle manufacturer with questions. Do
NOT modify the vehicle without approval from vehicle manufacturer
or authorized vehicle dealer.
•
Do NOT attach tether connecting strap to any moveable mechanism of
a vehicle seat.
•
In forward-facing installations, attach top tether to approved vehicle
tether anchorage points ONLY, as labeled by vehicle manufacturer.
WARNING:
•
The rear-facing bolster must only be used when fitting the car seat in
the rear-facing position.
•
Do not use the rear-facing bolster if it causes the bottom of the car
seat to lift up.
WARNING:
4
Pull to
tighten
3
1
Pin Pin
4
CLICK
3
2
19
18
Fitting & removing the rear-facing bolster
Using the top tether strap rear-facing
Summary of Contents for Radian 5
Page 54: ...Notes Notes 107 106...
