Dionex UltiMate 3000, System Installation And Application

Page: 13 / 73

UltiMate 3000 Nano and Cap - System Installation and Application
9
2.2.1 Power Connection
Use the power cords from the accessories kits to connect the modules to the mains. The
instruments are equipped with a standard power supply unit with an automatic voltage
selector. Thus, no adjustment is required to adapt the line voltage to local voltage
requirements.
Please note: The SRD-3600 solvent rack is usually connected to the mains via the
pump (
→
Fig. 2). However, an external power supply unit (part no.
6510.0004) is available as an option.
2.2.2 Interfaces for Device Control
Apart from the solvent rack, all modules of an UltiMate 3000 system can be connected to the
server PC separately. However, Dionex recommends interconnecting the modules, and then
connecting the system to the Chromeleon server PC via only one USB connection, e.g., from
the autosampler (
→
Fig. 2).
Please note: The SRD-3600 solvent rack can be operated with Chromeleon via the
pump.
For information about the connection ports on the system modules, as well as the connector
pinout, refer to the
Operating Instructions for the respective instrument.
2.3 Opening the Front Panel
To provide easy access to the components in the instrument compartments, the front panels of
the autosampler, detector, pump, and solvent rack tilt upward. The open cover locks in its
topmost position. The front panel of the flow manager tilts downward.
Important: When lifting or moving an instrument, always lift by the bottom or sides.
Lifting the instrument by the front panel may damage the front panel door.
Important: Lorsque vous soulevez ou déplacez un instrument, saisissez la toujours par
le dessous ou les côtés l'unité. Soulever l'unité par le panneau avant risque
d'endommager la porte du panneau avant.