Dinstar SBC1000, User Manual

Page: 14 / 71

2 Installation
SBC1000 Session Border Controller
Copyright©2011-2018 Dinstar
8
Installation Tools

Screwdriver

ESD wrist strap

Ethernet cables, power wires, telephone wires

Hub, telephone set, fax, and small PBX

Terminal (can be a PC which is equipped with hyperterminal simulation software)
Unpacking
Open the packing container to check whether the SBC1000 device and all accessories have been in it:

One SBC1000 device

One 1.8-meter-long of power wire (AC 250V/4A)

Two network cables

One grounding cable

One serial console cable

Flanks and screws
2.2 Installtion of SBC1000
Put SBC1000 into Shelf
Put the SBC1000 device on the shelf or cabinet horizontally;
Connect SBC1000 to Network
SBC1000 has five network ports, namely the gigabit network port for services (from GE0 to GE3) and the gigabit
network port for network management (Admin). It is advised to connect GE0, GE1, GE2 or GE3 to the IP
network.
Both GE0/GE1/GE2/GE3 and Admin can be used to carry out management on SBC1000, but generally
GE0/GE1/GE2/GE3 are put in use. Admin is used when there is a need to separate management-related processing
from service processing on SBC1000.