DWG2000-8G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
10
3. Network Configuration
In this chapter we will introduce the initial configuration of DWG2001 gateway. All of the
network parameters of the gateway can be configured by IVR guidance.
3.1 Preparation
Please ensure the following stepes are done properly before IVR setting:
Prepare an analog telephone or mobile phone
Make sure the gateway is power on
Make sure the gateway is connected with the network
Completed the SIM installation
Make sure that the current mobile network is working
3.2 Attentions
In each step, if user hears an IVR message of “setting successful”, which means that user has
finished this step successfully. However, if user hears a “setting failed” message, please check
redo theat step again.
DWG2001 can work in two modes: route mode and bridge mode. when the gateway is under
bridging mode, user should configure network parameters of WAN port; when the gateway is
under the route mode, user should configure LAN port.
3.3 General Feature Codes for System Setting
Table 3-3-1 Feature codes for system setting
Dial numbers
Features
*114#
Play the phone NO.
*115#
Check the TT number of gateway (using just when the device interconnects
with other series of DINSTAR products)
*150*a#
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is static IP
address mode, *150*2# is DHCP mode
*152*a*b*c*d
#
Configure IP address, a, b, c, d are the four fields of IP address.
*153*a*b*c*d
#
Configure subnet mask. a, b, c, d are the four fields of the subnet mask
*156*a*b*c*d
#
Configure the device gateway, a, b, c, d are the four fields of the device
gateway
*158#
Report the IP address
*157
Setting the work mode (route or bridge), * 157 * 0 # is route mode, * 157 *
1 # is bridge mode
*195#
Play record
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
