33
E2
E1
The HOLD function can be terminated ahead of time even once
again starting the welding.
Once
15
seconds have passed (HOLD FUNCTION) the control
panel goes back to the PRESETTING phase.
JOB
1 - CREATING AND SAVING A JOB
This operation makes it possible to create and save welding set-
tings (points) that can be called up by the operator at any time.
The control panel provides the possibility of saving a total of
99
JOBS
spread over all the welding processes. There are not lim-
its to the quantity or position of the points that can be saved for
each process!
When it leaves the factory the welding machine does not have
any JOBS saved in it and so the operator will find the control pan-
el in this condition:
Having defined the parameters the operator needs to do their work
correctly, they can be saved by creating an AUTOMATIC WELD-
ING POINT (JOB), proceeding as follows:
1) Hold the SAVE “MEM” key (T2) down for at least 2 consec-
utive seconds until both displays show the flashing wording
that represent the first AUTOMATIC WELDING POINT (JOB)
free and/or available to the operator that can be used for sav-
ing the data (e.g.:
A01
).
T2
To be able to choose another automatic welding point (JOB)
that is free for saving the data, simply turn one of the two EN-
CODER (E1-E2) knobs until you reach the required point.
E2
E1
WARNING:
If all the automatic welding points (JOBS) are occu
-
pied, the check automatically goes to the first automatic welding
point (JOB A01) as shown in the figure below).
2) Hold down the SAVE “MEM” (T2) Key down for at least 2 con-
secutive seconds to save JOB and automatically load the set-
tings / parameters (including special functions) for the JOB just
saved.
3) To exit the JOB, press and release the WELDING PROCESS
SELECTION key (T2).
T2
2 - JOB SELECTION
Select the JOB, pressing and releasing, even various times if nec-
essary, the WELDING PROCESS SELECTION key (T2) until the
corresponding LED lights up.
T2
3 - PRE-SETTING / VIEWING MEMORISED JOB DATA
Since the parameters are memorised, within each JOB, viewa-
ble but not modifiable, the pre-setting phase does not exist, but
the operator can see and verify the settings, previously saved
and memorised, pressing and releasing the PARAMETER SE-
LECTION key - A (T1) or in alternative the PARAMETER SELEC-
TION key - V (T4).
The SPECIAL FUNCTIONS “Fx” Key (T3) contained within each
individual JOB can be viewed (but not modified) by simply keep-
ing the SPECIAL FUNCTIONS “Fx” key (T3) pressed for a dura-
tion of about
2
seconds.
The display of the parameters (special functions included) lasts
only a few seconds, then the panel shows, in an automatic way,
the previous working condition.
T4
T1
T3
4 - WELDING
During the welding the display shows the values, if possible meas-
ured, of the active parameters, based on the type of welding pro-
cess, memorised within the selected JOB.
