Operating Instructions
Installation & Notice
Entry Delay & Home Arm Settings
Features
Parameters
Appearance
The wireless garage door sensor is an accessory of smart alarm system.
It’s fashion design, energy saving, low battery alert supported and with long transmission distance. The indicator will light
up every 1 second in the event of low battery and push notification will be sent to your APP. When the shuttle door is opened
under armed status, the sensor will trigger alarm.
•
Working Voltage
DC 3V
•
Battery
1 × CR2032 button battery (3V)
•
Working Current
≤
40mA
•
Standby Current
≤
2μA
•
Transmission Distance
Up to 300m without obstacle
•
Transmission Frequency
433.92MHz
•
Working Temperature
-10
℃
~50
℃
•
Humidity
≤90%rh (non-condensing)
•
Weight
148.1g(battery not included) 159.5g(battery included)
•
Dimension
80.0mm*38.2mm*13.3mm ( L*W*H )
PCB Layout
Metal Canula
Magentic Part
Reed Part
Transmitter
LED Indicator
Metal Screw × 4
Transmitter
Screw Mounting Hole
Battery Replacement Instructions
1. Working principle
The transmitter sends trigger signal to paired main panel when the magnet mounted near is moved apart.
2. Pairing with main panel by App
①
Scan the QR code on the sensor.
②
The pairing result would be confirmed in APP.
• Pull out the battery insulative strip.
• Pairing main panel by App before installing.
• Install the magnetic part on garage door and reed part on
ground with screws provided. Attach the transmitter with
double-side sticky tape on wall.
• Make sure the distance between reed part and magnetic
part is less than 1cm.
The Entry Delay feature can be turned ON individually to make the system waiting few seconds before
triggering alarm which is caused by the sensor.
This product features ‘Entry Delay,’ ‘Home Arm’ modes and can be selected in App.
Entry Delay feature : Under Arm/Home Arm mode, in the event the sensor is triggered, the
system will wait for preset time then set off the alarm.
Home Arm feature : Under Home Arm mode, when the sensor with this feature is enabled and triggered ,
the alarm will be set off.
①
Insert the flat blade of a small screwdriv-
er into the pry-off slot of transmitter, twist
the blade to remove the cover.
②
Replace with 1 × CR2032 button battery.
