Dino 210XT, Operating Instructions Manual

Page: 71 / 119

DINO 210XT
71
-
check the condition of the boom joint
- check the bearing and the pin of the boom joint and the locking of the pin
-
check the condition and attachment of the articulated arm joint pins and bearings
-
check the support outriggers and their footplates
- check the mechanical structure of the outriggers and the welded seams
The structures must not show signs of deformations or cracks No fractures or cracks
allowed in the welded seams.
-
check the footplates for deformations, cracks or breaches
Also check that the footplate can turn freely on its joint.
- inspect the boom.
-
extend the telescope and check that there are no permanent deformations, dents or
traces of substantial wear in the boom
-
also check the welded seams for wear, cracks or breaches
-
check the boom attachment for cracks or breaches
-
check the condition of the platform brackets
-
check the locking of the platform pin
- check the condition and attachment of the flyer-chain, the locking of the pins and the
tightness of the spring
- check the condition of the cable chain, its clamp brackets as well as the tightness of
the screw connections
- check the play and attachment of the gliding surfaces on the boom.
- inspect the platform
-
general condition
- check that the platform does not show signs of deformations, substantial wear or
buckles
- check that the handrails, the steps, the gate and the attachment of the gate are in
order
- check that the lock of the gate and the gas spring are in order
-
check the condition of the platform floor plate
- check the platform carrier for notable buckles or deformations
- check all protective covers
-
check the condition of the support outrigger cylinder guards
-
check the condition of the slave cylinder guard
-
check the condition of the boom end cover, turning device covers, chassis control
panel cover, safety device cover, platform control panel cover and the rear light
cover
-
perform visual inspection of all screw connections
-
inspect the turning device
-
general condition
-
check the play and attachment of the angular gear
-
check the condition of the gear ring
- check the play of the turning gear
-
check the tightening torque of the turning bearing´s attachment screws (M16 280
Nm, M12 150 Nm)
-
check the attachment of the turning motor