DINGO D Series, User Manual

Page: 30 / 42

Rev 1.3 22.07.09 Dingo Reference Manual
30
SET/EVNT/STRT Selection Summary
STRT Event starts when Value
to set
0 Always starts -
1 Time > setting (0.0-23.9) TIME
2 Solar panel voltage
(open circuit) > setting # SOLV
3 Solar panel voltage
(open circuit) < setting # SOLV
4 External voltage
VEXT * > setting VEXT
5 External voltage
VEXT * < setting VEXT
6 PB** is on and time > setting TIME
7 PB** is off and time > setting TIME
8 Repeat start at 10 min intervals
if time > setting TIME
9 Repeat start at 30 min intervals
if time > setting TIME
10 Repeat start at 1hr intervals if
time > setting TIME
11 Repeat start at 2hr intervals if
time > setting TIME
12 Battery voltage > setting VBAT
13 Battery voltage < setting VBAT
14 Repeat start at a set rate
(0-240 min) RATE
15 Repeat start at a set rate
(0.0-24.0h) RATE
#Note: After up to 1 min delay if the solar charge
switch has not turned off.
* Note: The user can select where VEXT is
measured. If BSET is set to 2, then VEXT is the
voltage measured by the B+ sense input (relative
to BAT+ in the negative direction). The maximum
VEXT measurable this way is 27V. If BSET is not 2,
then VEXT can be measured by a bus accessory,
**Note: “PB” means a push-button switch. If you
wish to use this option, you can wire a switch or
other contact closure device between the B+ sense
terminal (green terminal block) and the BAT+
terminal, and select BSET = 2.
Step 4
Select a STOP setting in this table to tell the
Dingo what signifies the end of the “event”. After
setting the STOP value, a short-push will move
you to the associated setting. For example, if you
set STOP to ‘1’, you will see ‘TIME’.
Once started, the “event” will then continue
until the time reaches the time you specify in
the TIME setting. To allow events which go past
midnight, there are special rules for STOP=1.
SET/EVNT/STOP Selection Summary
STOP Event stops when Value
to set
0 Stop never active -
1 Time > setting (0.0-25.2) TIME
2 Solar panel open circuit voltage
> setting # SOLV
3 Solar panel open circuit voltage
< setting # SOLV
4 External voltage VEXT *
> setting VEXT
5 External voltage VEXT *
< setting VEXT
6 PB** on and time > setting TIME
7 PB** off and time > setting TIME
8 Repeat stop at 1 min intervals if
time > setting TIME
9 Repeat stop at 3 min intervals if
time > setting TIME
10 Repeat stop at 6 min intervals if
time > setting TIME
11 Repeat stop at 12 min intervals
if time > setting TIME
12 Battery voltage > setting VBAT
13 Battery voltage < setting VBAT
14 Stop after a set run time
(0-240min) RUN
15 Stop after a set run time
(0.0-24.0h) RUN
#Note: After up to 1 min delay.
*Note: “VEXT” has the same meanings as in the
STRT table.
**Note: “PB” has the same meanings as in the
STRT table.
7