Rev 1.39 03.10.17
Firmware Version 143 ff.
Dingo 4040P Reference Manual
25
TEST
BOOST
V
+
-
+
-
+
-
Fuse/Breakers
Battery
+
–
B- Sense wire
(Connect to Battery
Negative Terminal)
Fuse/
Breakers
Connect
close to
battery
terminals
Solar
Panel(s)
+
-
(NOTE: Low Current 'B Sense' wires can be significantly smaller than other wires.)
LOAD
SET/MODE/BSET Selection Summary:
Selection
Function
0
B- input used for battery
negative voltage sensing
1
2nd battery voltage sensing
2
Used as the VEXT voltage by
the event controller
3
force equalise when connected
to BAT-
Fig. 7.5.3A - Battery Sense Input
TEST
BOOST
V
+
-
+
-
+
-
Battery
+
–
Push Button
Light
Fig. 7.5.3B - Push button connection
7
If the B- input is not being used for this, then it
can be used for sensing the voltage on a second
battery being charged or for providing a voltage
input for the event controller (VEXT).
Some inverter-chargers, such as the SP PRO,
can communicate to the charge controller when
they want to export power to the grid. Selecting
BSET=3 enables this.
‘Push Button’ Switch Input
To use the B- sense input as a switch event input,
wire a switch (or other voltage free contact
closure device) between the B- terminal (green
terminal block) and the Bat- terminal (and set
BSET = 2). See Figure 7.5.3B
This is an example of using a push button
switch to turn on a light - see section 7.6 Event
controller example 2 for setting details.
