Dinel ULM -70 Series, Instruction Manual

Page: 10 / 24

"AUTO MIN" (Automatic setting of the 4mA limit)
After the mode is enabled, the actual measured level will be set as the min. level. The 4mA value
will be assigned to the level meter output. The setting is recommended only if the tank can be
fl ooded up to the required min. height.
B
ASIC SETTINGS
Before the fi rst starting, you must carry out the basic con fi guration
of the level meter. The settings are accessible in the basic menu
under the item "BASIC ADJUSTMENT".
ACTUAL LEVEL: Actual distance in mm
DISP: Display of measured values on the display
U: Unit selection (mm, cm, m, l, m
3
,mA, %)
ACTUAL LEVEL: Actual distance in mm
DISP: Display of measured values on the display
U: Unit selection (mm, cm, m, l, m
3
,mA, %)
O
PERATION
Set the level meter using 3 buttons placed on the display module (see Chapter Set-up elements).
After 5 min. of inactivity, the level meter automatically returns back to the measurement mode.
If the password is active, the level meter will be also locked. The values that have not been
con
fi rmed using the button [OK] will not be saved! After the meter is locked, you cannot change
the setting! When you attempt to edit, the words "NO PASSWORD" will appear on the display.
How to unlock the level meter is given on page 17.
1. Fill up the tank up to the required level.
2. Press the button
[OK]
to access the basic menu. Use the same button to select the item "BASIC
ADJUSTMENT" and then "AUTO MIN".
3. Now the item "AUTO MIN" is displayed. The level meter assigns the 4mA value for the measured
value automatically.
4. Using the buttons
[OK]
and
[ ↑ ↓ ]
, set the values to display on the display "DISP" and select the
units "U".
5. After the setting is completed, save the data using the button
[OK]
. By repeated pressing the
button [ESC] , you leave the menu and the display of the level meter and return back to the
measurement mode.
"AUTO MAX" (Automatic setting of 20 mA limit)
After the mode is enabled, the actual measured level will be set as the max. level. The 20mA value
will be assigned to the level meter output. The setting is recommended only if the tank can be
fl ooded up to the required max. height.
www.jetec.com.tw
久德電子 TEL: +886-4-23729418 FAX: +886-4-23724011 (40349) 台中市西區福人街11號