TRP 100 M, TRP 100 W
English
www.dimplex.de/en
1810/B
EN-3
5. Cleaning
The device must be disconnected from the mains and
allowed to cool down before cleaning and
maintenance. Clean the outside of the device using a
soft, damp cloth. Do not use scouring powder or
furniture polish as this may damage the surface. Dust
which gathers inside the device can be removed from
the outside using a vacuum cleaner.
6. Faults
If Err appears on the display, there is a fault.
3. Electrical connection
The voltage specified on the type plate must match the
line voltage.
The cable must not be in contact with the casing.
It is recommended that a separate circuit be provided
for the power supply.
The device must only be installed and repaired by a
qualified electrician in accordance with the applicable
safety regulations. Heating device must be earthed!
Connection may only take place on securely routed
cables!
A disconnecting device with a contact opening of at
least 3 mm at each pole (e.g. circuit breaker) must be
provided in the permanently installed wiring.
4. Overload protector
For your safety, the heating device is equipped with an
overload protector. If the air circulation is interrupted
(e.g. due to the air grille being covered or closed), the
device switches off automatically.
In this case, the power supply to the heating device
should be disconnected for a few minutes (disconnect
the plug, switch off the fuse) to allow the device to cool
down sufficiently.
Before recommissioning the device, remove the
reasons for the overload protector being triggered.
Deleting the error message
Press and hold the ENTER key for ten seconds.
Err disappears.
Device is ready for operation again.
800
375
Display
Meaning
Measures
Err1
Temperature sen-
sor faulty.
Notify the factory
after-sales service.
Err2
Window monitor-
ing triggered.
Close window.
Delete error message.
Deactivate the function
where applicable,
see chapter 11.6
Err3
Heating device
overheated.
See chapter 4.
Delete error message.
