English
TRP 100 M, TRP 100 W
EN-2
1810/B
www.dimplex.de/en
NOTE
NOTE
NOTE
NOTE
NOTE
NOTE
2. Assembly, installation, minimum clearance
CAUTION!
Do not install the device directly below a wall
socket.
The minimum clearances must be observed.
In addition, a clearance of 300 mm is to be maintained
in front of the unit.
The heating device must be aligned horizontally and
installed on a vertical wall (see illustration).
All dimensions in mm.
During assembly, the safety area must be complied
with according to the current installation regulations.
The supply connection socket must be accessible after
installation.
Make sure that the inflow and outflow of air at the top
and bottom of the device are unimpeded
.
Installation on wooden walls is permissible.
Mounting the towel rails
2 towel rails are included in the scope of supply. They
can be mounted on the rear of the device with 4 screws
each in 4 different positions.
Wall mounting
The original wall bracket supplied on the rear of the
device must be used!
Look out for electric cables or pipework in the wall
when drilling.
Remove the wall bracket from the rear side of the
device.
To do this, press both springs down.
Drill the fastening holes.
Screw the wall bracket securely to the wall.
Hook in the openings on the left on the rear of the
device on the wall bracket.
Fold the device to the right and
engage in the springs to lock.
270
465
300
B
150
114
300
A
Model
A
B
TRP 100 M
418 mm
1088 mm
TRP 100 W
430 mm
1100 mm
