INSPECTION AND CLEANING
Check that all the lamps are functioning. If any thermostatic or time controls are fitted
1.
ensure that the supply is ‘on’ before checking lamps. Any failed lamps should be
replaced (see lamp replacement). Remove any accumulated dirt and check wiring and
connections.
Clean the lamp(s) and reflector(s) using a mild detergent solution and soft cloth.
2.
Do not use any abrasive or caustic cleaners. Dry with a soft cloth. Avoid touching
either, the quartz lamp sleeve or the aluminium reflector with bare fingers. If they
are accidentally touched remove any finger prints using a soft cloth moistened with
methylated spirit.
Check that the lamp(s) are properly located in the spring retaining clips and that they
3.
have not been disturbed by cleaning. The lamps should be pushed fully back into the
clips for applying light pressure on the end caps only.
SAFETY IN OPERATION
The heater is operated by simply switching on the electrical supply, or, if used in
conjunction with a control system, then the supplier’s instructions must be observed.
ALWAYS disconnect the heater from the supply before attempting to work on or near it.
NEVER operate the heater with a high accumulation of dust or dirt on the lamp(s) or
reflector or with a damaged or corroded reflector.
This appliance is not intended for use by children or other persons without assistance
or supervision if their physical, sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure they do not play with the appliance
NEVER use the heater outside or in contact with water.
NEVER use the heater where flammable dusts, gases or vapours, etc. are likely to be
present in the atmosphere.
NEVER operate the heater in close proximity to the skin or eyes.
NEVER allow materials which could be damaged or ignited by the radiated heat to be
placed in close proximity to the heater.
NEVER cover the heater – even when it is switched off.
ALWAYS refer to these instructions before attempting to dismantle the heater.
AFTER SALES SERVICE
Your Dimplex Quartz Heater is guaranteed for one year from the date of purchace. We
undertake to exchange or repair free of charge within this period, any part found to be
defective due to a manufacturing fault.
Should you require after sales service, please get in touch with the supplier through whom
you purchased the appliance, or the contact number on your Warranty leaflet.
Please do not initially return a faulty appliance or part of an appliance as this may result
in transit damage and/or delay in providing service. Let us know your difficulty quoting the
model number and series letter of the appliance. We will then take the appropriate action.
Tel:
+44
(0)191 490 1547
Fax:
+44
(0)191 477 5371
Email:
Website:
www.heattracing.co.uk
www.thorneanderrick.co.uk
