Dimplex HPL 6S-TURW, Installation And Operating Instructions Manual

Page: 27 / 56

www.dimplex.de 452163.66.68 · FD 9705 EN-11
HPL 6S-TU(R)W English
7 Complies with the European safety regulations
6 6
8 Additional model features
8.1 Type of defrosting Reverse circulation Reverse circulation
8.2 Frost protection, condensate tray /
Water in device protected against freezing
7
Yes Yes
8.3 Maximum operating pressure (heat sink) bar 3.0 3.0
9 Heat output COP
2
9.1 Heat output / COP EN 14511
at A-7 / W35 kW / --- 3.9 / 2.9 3.9 / 2.9
at A2 / W35 kW / --- 5.0 / 3.9 5.0 / 3.9
at A7 / W35 kW / --- 6.3 / 4.7 6.3 / 4.7
at A7 / W45 kW / --- 5.9 / 3.5 5.9 / 3.5
at A10 / W35 kW / --- 6.6 / 4.7 6.6 / 4.7
10 Cooling capacity / COP
2 4
10.1 Cooling capacity / COP EN 14511
at A27 / W18 kW / --- - 5.5 / 3.8
at A27 / W7 kW / --- - 3.7 / 2.7
at A35 / W18 kW / --- - 4.9 / 3.0
at A35 / W7 kW / --- - 3.6 / 2.3
1. For air temperatures between -22°C and -5°C, flow temperature increasing from 45? to 60?.
2. These data indicate the size and capacity of the system according to EN 14511. For an analysis of the economic and energy efficiency of the system, other parameters, in particular
the defrosting capacity and regulation, should also be taken into consideration. These figures are only achieved with clean heat exchangers. Instructions for care, commissioning
and operation can be found in the relevant sections of the installation and operation instructions. The specified values have the following meaning, e.g. A7/W35: outside air tem-
perature 7 °C and heating water flow temperature 35 °C.
3. The heat output and COP is reduced by approx. 5 % in lower operation
4. The maximum sound power level under full load can increase by up to 5 dB(A).
5. The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.
6. See CE declaration of conformity
7. The heat circulating pump and the heat pump manager must always be ready for operation.