Dimplex DX 410E, Installation And Operating Instructions Manual

Page: 9 / 40

www.dimplex.de/en 1810/D EN-2
DX 410E - DX 430E English
Wall mounting
NOTE NOTE
The original wall bracket supplied on the rear of the
device must be used!
NOTE NOTE
Look out for electric cables or pipework in the wall
when drilling.
Remove the wall bracket from
the rear side of the device.
To do this, press both springs
down.
Drill the fastening holes.
Screw the wall bracket
securely to the wall.
Hook the device in the bottom slots of the wall
bracket.
Fold the device up and engage in the springs to
lock.
3. Electrical connection
The voltage specified on the type plate must match the
line voltage.
The cable must not be in contact with the casing.
It is recommended that a separate circuit be provided
for the power supply.
The device must only be installed and repaired by a
qualified electrician in accordance with the applicable
safety regulations. Heating device must be earthed!
Connection may only take place on securely routed
cables!
A disconnecting device with a contact opening of at
least 3 mm at each pole (e.g. circuit breaker) must be
provided in the permanently installed wiring.
4. Overload protector
For your safety, the heating device is equipped with an
overload protector. If the air circulation is interrupted
(e.g. due to the air grille being covered or closed), the
device switches off automatically.
In this case, the power supply to the heating device
should be disconnected for a few minutes (disconnect
the plug, switch off the fuse) to allow the device to cool
down sufficiently.
Before recommissioning the device, remove the
reasons for the overload protector being triggered.
5. Cleaning
The device must be disconnected from the mains and
allowed to cool down before cleaning and
maintenance. Clean the outside of the device using a
soft, damp cloth. Do not use scouring powder or
furniture polish as this may damage the surface. Dust
which gathers inside the device can be removed from
the outside using a vacuum cleaner.
Model A B C D
DX 410E
DX 415E
DX 420E
355
mm 340
mm 138
mm 110
mm
DX 425E
DX 430E 475
mm 310
mm 168
mm 80
mm
230
350
15
110 110
A
102
C
D
6
B
450
230