Dimension One Spas Bay Collection, Owner'S Manual, Page: 63 / 72

2004 Bay Collection
Owner’s Manual
14. Once the spa is full, turn on the circuit breaker (not supplied by Dimension One Spas). Flashing
dashed lines will appear for 30 seconds on the Digital Display Window followed by the current
water temperature (flashing).
15. Push the Jet Pump 3 Button once to turn on Pump 3. Let the
system run for 10 to 15 seconds to prime the pump.
16. Then push the Jets Button on the Dynamic Massage Sequencer
to the right of the Top Side Control to start Pump 1. Let it run
for 10 to 15 seconds to prime Pump 1. Press the button again to
shut the pump off.
17. Then push the Jets Button on the Dynamic Massage Sequencer
to the left of the Top Side Control to start Pump 2. Let it run for
10 to 15 seconds to prime Pump 2. Press the button again to shut
the pump off.
18. If there is no jet action, then the water level is too low or there is
air trapped in the plumbing lines. To eliminate the trapped air, turn
the pumps on and off several times to force the trapped air
through the pumps. If there is still no jet action, and the bleeder
valves were removed as previously described, turn off the pumps
and loosen the top pump unions slightly to let any trapped air
escape. Re-tighten the pump unions and turn the pumps on again.
Turn the pumps on and off several times until jets function
properly.
Ozone bubbles will continue to release from the skimmer recess UltraPure
™
bleeder valve as
long as the valve remains open. Once the pumps are primed, be sure that the bleeder is closed
tightly.
19. When the jets are in full operation, replace and close the bleeder
valves and push the UP/Down Buttons until your desired water
temperature (set temperature) is indicated on the Digital Display
Window. The Digital Display Window will then display your set
temperature for thirty seconds before changing to display the
current water temperature.
57