Dimension One Spas Bay Collection, Owner'S Manual

Page: 61 / 72

2004 Bay Collection
Owner’s Manual
Initial Startup
1. Locate the Top Side Control.
2. Locate the hose bib that is included in the owner’s manual packet. The owner’s
manual packet is shipped inside the equipment compartment. Your dealer should
provide you with this packet during installation.
3. Locate the male fitting at the bottom of the lower left corner of the hot
tub – below the skirt on the left corner of the side containing the Top
Side Control.
4. Close the valve on the side of the hose bib and screw it onto the end of
the hose bib. Check to ensure the cap on the hose bib is secure to avoid
leaks when you add water to the spa.
5. Remove the panels below the Top Side Control and the right side to expose the pumps and the
Lower Equipment Compartment.
6. There are two pump unions and two gate valves per
pump. The pump on the left in the picture shows the
typical locations of the Sarena Bay
®
pump unions and gate
valves. (The Lotus Bay
™
pumps are located behind the corner
panel to the left of the Top Side Control.) Check to make
sure the pump unions are hand tight to prevent the
possibility of leakage. Next, check the gate valves to make
sure they are fully opened and that the red safety clips are
snapped into place. The other pumps in the picture are
identified by the additional circles. Be sure to check pump
unions and gate valves on all three pumps.
7. After you finish checking the pump unions and gate valves, remove the shipping bolts from the base
of each pump and rotate the swivel lock, located at the rear of each pump, away from the pump.
55