Dillon FI-90, User Manual

Page: 22 / 24

22
VERSION version - Under version are the Weigh-Tronix part number for
the FI-90 force indicator, and the revision number for
the software found in your unit. Weigh-Tronix part
numbers are divided into two parts: a five-digit prefix
and a four-digit dash number.
dISPLAY display - From this display: dISPLAY , press PRINT / SE-
LECT and the top row of annunciators turns on.
Press PRINT / SELECT again and a dynamic test is
run. Press MENU to stop the dynamic test or
consecutively press MENU to step through the
display test routine. Press PRINT / SELECT when
the dynamic test is active to return the display to
dISPLAY .
buttonS buttons - With bUttOnS displayed, press PRINT / SELECT
and an underscore will appear on the screen. Press
any key except MENU to check for proper key
functioning. After testing the keys, press MENU to
return the display to bUttonS .
OutPutS outputs - These tests allow you to turn the cutoffs on and off
automatically in sequence, under CYCLE , or indi-
vidually, under CUTOFF 1 and CUTOFF 2 . When
you exit the outputs test, the cutoffs revert to their
proper condition according to the applied gross force.
input input - This test tells you how the remote control input is
configured. It may be off, or it may be configured as
a remote PRINT key control, a remote GROSS /
PEAK key control, or a remote ZERO / CLEAR key
control. With input displayed, press PRINT /
SELECT and an underscore will appear. Activate the
external remote switch, and the display will print the
name of the key to which the remote input is dedi-
cated, verifying proper functioning of the connection.
VoltAgE voltage - The input power voltage is displayed in tenths of a
volt. In the battery versions, the BATTERY annuncia-
tor comes on when the voltage reaches approxi-
mately 5.4 volts.
A to d A to D - Displays the analog-to-digital counts. The span is
normally 20,000 counts per millivolt per volt. With a
calibrator at zero millivolts per volt, the displayed
value should be between -200 and +200.
SEriAL serial - Tells you if the serial output is ready or busy. A
jumper connecting pins 4 and 8 of the serial port will
cause READY to be displayed.
Main Displays Viewed
in the Test Mode Menu