26
2. Set the alarm holding time and alarm trigger options. The setup steps are the
same as motion detection. Please refer to the motion detection chapter for
details.
3. Click the “Save” button to save the settings.
4. Set the sensitivity of the Video Tampering detection. Click the “Sensitivity” tab
to go to the interface as shown below.
Drag the slider to set the sensitivity value or directly enter the sensitivity value in
the textbox. Click the “Save” button to save the settings.
The sensitivity value of Scene Change Detection: The higher the value is, the
more sensitive the system responds to the amplitude of the scene change.
The sensitivity value of Video Blur Detection: The higher the value is, the more
sensitive the system responds to the blurriness of the image.
The sensitivity value of Abnormal Color Detection: The higher the value is, the
more sensitive the system responds to the obscuring of the image.
※
The requirements of the camera and surrounding area
1. Auto-focus should not be enabled for video tampering detection.
2. Try not to enable video tampering detection when light changes greatly in the
scene.
3. Please contact us for more detailed application scenarios.
5.4.2
Line Crossing
Line Crossing: Alarms will be triggered if the target crosses the pre-defined
alarm lines.
Go to Config > Event > Line Crossing interface as shown below.
Summary of Contents for MEGApix DWC-MT95WiATW
Page 23: ...19...
Page 56: ...52 7 2 Dimensions...