Digital Watchdog MEGApix DWC-MT95WiATW, User Manual, Page: 24 / 61

20
5.3 Alarm Configuration
5.3.1 Motion Detection
Go to Alarm > Motion Detection to set a motion detection alarm.
1. Check the “Enable” check box to activate motion-based alarms. If unchecked,
the camera will not send out any signals to trigger motion-based recording to
the NVR or CMS, even if there is motion in the video.
Alarm Out: If selected, this would trigger an external relay output that is
connected to the camera on detecting a motion-based alarm.
Trigger Snap: If selected, the system will capture images on motion detection
and save the images on an SD card.
Trigger SD Recording: If selected, the video will be recorded on an SD card on
motion detection.
Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address
must be set first in the Email configuration interface), the captured pictures and
triggered event will be sent to those addresses.
Trigger FTP: If “Trigger FTP” and “Attach Picture” are checked, the captured
pictures will be sent to an FTP server address. Please refer to the FTP
configuration chapter for more details.
2. Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab
to go to the interface as shown below.