Digital Projection
M-Vision Laser 21000 WU
Rev A November 2018
Page 19
Important Information
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm
your choice.
The
POWER
indicator on the control panel will start flashing amber, the projected image will turn
off and the cooling fans will run for a short time until the
POWER
indicator goes steady red to
indicate that the projector has entered STANDBY mode.
2.
If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.
Selecting an input signal
1. Connect one or more image sources to the projector.
2. Select the input you want to display:
•
Press one of the input buttons on the remote control.
•
Alternatively, open the On-screen display (OSD) by pressing
MENU
. Highlight
Input
from the
main menu, press
ENTER/OK
and then select an input signal using the
UP
and
DOWN
arrow
buttons. Press
ENTER/OK
to confirm your choice.
Selecting a test pattern
To display a test pattern:
•
Press
TEST
on the remote control. If necessary, press again to change the test pattern. Test
patterns are displayed in the following order:
White, Black, Red, Green, Blue, Checkerboard, CrossHatch, V Burst, H Burst, ColorBar,
Plunge, Off
After the final test pattern, the projector exits test pattern mode and returns to the main image. To
view test patterns again, you need to press
TEST
again.
•
Alternatively, open the OSD by pressing
MENU
. Highlight
Test Patterns
from the main menu,
then select a test pattern using the
LEFT
and
RIGHT
arrow buttons.
