Digital Projection
M-Vision Laser 21000 WU
Rev A November 2018
Page 18
Important Information
Connecting the power supply
Firmly push the mains connector into the
socket
1
, then press the
ON/OFF switch
2
.
Use only the power cable provided.
Ensure that the power outlet includes a ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch
next to the power connector. (See
Connecting the power supply
above.)
2. The
POWER
indicator lights red to signal that the projector is in STANDBY mode. Press one of
the following buttons:
•
On the remote control, the
ON
button
•
On the projector control panel, the
POWER
button.
The fans begin working, then the
POWER
indicator begins flashing green. When the flashing
stops, the
POWER
and
LIGHT
indicators both light steady green. The projector is switched on.
1
2
