Digital Projection
M-Vision Cine 320 3D Series
OPERATING THE PROJECTOR
Installation and Quick-Start Guide
8
Rev E July 2014
Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector.
2. When the self-test has completed, the
power
indicator on the projector control panel shows blue to indicate that the projector is in
STANDBY mode and the lamp is switched off. Press and hold for three seconds either of the following:
•
The
POWER
button on the control panel
•
The
ON
button
on the remote control
The power
indicator on the control panel flashes blue for a few seconds whilst the lamp comes up to full brightness. When the projector is fully
switched on and ready for use, the power indicator switches off.
Switching the projector off
1. Press
POWER
on the control panel or the
POWER
button
on the remote control, then press the button again to confirm.
The lamp will switch off, the power indicator on the control panel will start flashing in blue and the projector will be in STANDBY mode
while cooling off.
2.
Wait until the power indicator has stopped flashing and the fans have stopped working, then disconnect the power cable.
Notes
For full details of how to use the
controls and the menu system, see
the
Operating Guide
.
Even if the power indicator has
stopped flashing, please allow the
lamp to cool off for five minutes
before:
•
disconnecting the power
•
moving the projector
•
changing the lamp
