Digital Projection HIGlite 8000 Series, User Manual

Page: 17 / 84

Digital Projection
HIGHlite 8000 Series
OPERATING THE PROJECTOR Installation and Quick-Start Guide
11 Rev F July 2014
Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
2. Wait until the self-test has completed and the standby indicator on the projector control panel shows amber. The lamp will be off and the
projector will be in STANDBY mode.
3. Press
ON
on the remote control or the control panel and hold for three seconds, to switch the projector ON. The power indicator on the
control panel will show green, the lamp will light and the shutter will open.
Switching the projector off
1. Press OFF on the remote control or the control panel, and hold for three seconds. The power indicator on the control panel will show
amber, the lamp will go out and the cooling fans will run for a short time until the projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the power connector and then disconnect
the power cable from the projector
Selecting an input signal
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within two or
three seconds.
Notes
The self-test is running when all the
LEDs on the control panel are lit.
Always allow the lamp to cool for
five minutes before:
- disconnecting the power
- moving the projector