Digital Projection HIGlite 8000 Series, User Manual

Page: 13 / 84

Digital Projection
HIGHlite 8000 Series
REMOTE CONTROL Installation and Quick-Start Guide
7 Rev F July 2014
Remote Control
1
Transmit indicator
Flashes when the remote control sends a signal to the projector.
2
Power ON / OFF
3
Shutter OPEN / CLOSE
4
Arrow buttons
Control lens movement.
5
EXIT button
Exits a lens control mode entered by pressing one of the lens control buttons.
6 Remote control backlight ON / OFF
Make the remote control buttons glow in the dark, or switch this feature off.
7
Lens control buttons
Use with the arrow buttons to adjust lens position, zoom and focus.
Infrared reception
The projector has infrared sensors at the front and back.
The angle of acceptance is 40°. Make sure that the remote control is within the angle of acceptance
when trying to control the projector.
VGA HDMI DVI 3GSDI
CVBS1 SVIDEO
CLOSE
1 2 3 4
COMP CVBS2
5 6 7 8
9 0 10+ #
MAIN SUB DUAL AUX
OFF ON
ALT
ROLL
PITCH YAW
FOCUS
CAL
SHIFT
ZOOM
EYE
SWAP
MAIN/PIP
SWAP
BRI CON GAMMA 3D
ON/OFF
PIP
ON/OFF
LOAD SAVE TEST ADDR
BACKLIGHT
R G B
PRESET
SHUTTER
OPEN
POWER
MENU
OK
EXIT
INFO
1
2
6
3
7
4
5
Remote control
40°
40°
Infrared reception
Notes
Only the controls shown highlighted
are used on this projector.
When any of the three lens control
buttons is pressed, the projector will
enter LENS ADJUSTMENT mode
and the blue transmit indicator on
the remote control will light for 10
seconds:
When no adjustment has been
made for 10 seconds, the LED will
go out and the projector will exit
LENS ADJUSTMENT mode. Press
the lens control button again to
resume adjustment.
To end the adjustment before 10
seconds has elapsed, press the
EXIT
button.
All other adjustments will be locked
out until the lens adjustment is
ended.
For more information about
LENS ADJUSTMENT mode, see
Adjusting the lens further in this
guide.
Infrared reception is confirmed by
the blue IR LED flashing on the
control panel.
The infrared receivers are disabled
when a remote control is connected
via a cable. For more information,
see Control Connections in the
Connection Guide .