Digital Projection
E-Vision Laser 5000 Series
Rev A January 2018
Page 16
Important Information
Connecting the power supply
Firmly push the mains connector
into the AC IN socket as shown in
the illustration.
Use only the power
cable provided.
Ensure that the power
outlet includes a ground
connection as this
equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Switching the projector on
1. Connect the power cable between the mains supply and the projector. (See
Connecting the
power supply
above.)
2. The
POWER
indicator lights green to indicate that the projector is in STANDBY mode. Press one
of the following buttons:
•
On the remote control, the
ON
button
•
On the projector control panel, the
POWER
button.
The
POWER
indicator begins flashing green. In approximately 20 seconds, the startup screen
appears and the projector is fully switched on.
The first time you use the projector, you can set OSD language from the quick menu. (See
Setting the OSD language
in the user manual.)
Switching the projector off
1. Press
OFF
on the remote control or
POWER
on the control panel, then press again to confirm
your choice. The
POWER
indicator light will flash green until the cool down period has completed,
the projector will then green solid light for
STANDBY
mode
2. If you need to switch the projector off completely, disconnect the power cable from the projector.