Digital Monitoring Products Canadain XR500, User Manual, Page: 23 / 80

XR500/XR100 Canadian User’s Guide 17 Arming and Disarming
Disarming the Area System from the keypad
1. Press the COMMAND key until ARM DISARM displays. During
entry delay this process starts at step 3.
2. Select DISARM to disarm areas.
3. The keypad displays ENTER CODE: . Enter your user code
and press COMMAND. The keypad displays ALL? NO YES.
4. Select YES to disarm all areas authorized for your user
code.
Select NO to disarm only certain areas individually. The
keypad then displays the name of each area authorized for
your user code followed by the NO YES display.
Select YES to disarm the area displayed.
Select NO to not disarm the area and display the next area.
5. If you are disarming the system out of a normally scheduled
time and you have the authority to extend a schedule,
the keypad then displays 2HR 4HR 6HR 8HR. Select the
number of hours to extend the schedule.
Note : If you do not have the authority to extend a schedule,
this option does not display.
6. After all areas have displayed and schedules extended, any
alarms or communication problems that occurred during the
armed period display.
7. If all areas have been disarmed, the keypad next displays
ALL SYSTEM OFF.
Quick Disarming
To quickly disarm a desired area, enter the area number followed
by the COMMAND key when the
ALL? NO YES
option displays.
All/Perimeter System Arming
Area Assignment: Your security system is divided into two
separate areas. Motion detectors, inside doors, and other interior
protection devices are assigned to the Interior area while windows
and exterior doors are assigned to the Perimeter area.
Perimeter or All: When arming an All/Perimeter system, the
keypad displays PERIM ALL. If you select ALL, you are arming
both the Perimeter and the Interior areas of the system. You will
want to arm both of these areas when leaving the premises with
nobody left inside. Selecting PERIM arms only the perimeter of the
system. Perimeter arming is when you’re staying inside but want
the comfort of knowing the exterior doors and windows are armed.
Perimeter arming allows you to move freely about inside without
setting off any interior alarms.
Instant:
During the exit delay time, you can cancel the exit and
entry delays and cause all zones to be instant zones. Just press the
far right Select key under INSTNT while the exit delay is displayed.
This immediately arms the exit zones. However, no entry delay is
provided and an alarm will occur should an entry door be opened.
System Ready/System Not Ready
When all zones in the system are in a normal condition and can be
armed without bypassing, the keypad displays SYSTEM READY. If
there are one or more zones that are not in a normal condition,
the keypad displays SYSTEM NOT READY. Pressing any Select key
during this display shows the zone number and name allowing you
to investigate the problem.
All/Perimeter Shortcut Key Arming
Arm Perimeter — Press 6 for 2 seconds.
Arm All —
Press 1 for 2 seconds.