Digital Equipment STARION 200i, Service Maintenance Manual

Page: 31 / 96

Digital STARION 200i/300i PC Utilities & Configuration
MCS Logistics Engineering - Nijmegen 31
S
T
A
R
I
O
N
2
0
0
i
3
0
0
i
Integrated Peripherals
(continued)
Menu Fields Settings Comments
Serial port 1 Auto
Disabled
3F8, IRQ 4
2F8, IRQ 3
3E8, IRQ 4
2E8, IRQ 3 Enables or disables onboard serial port 1 at the specified address.
Select Auto unless interrupts IRQ4 and/or IRQ3 are allocated as a
computer resource.
Two devices cannot share the same IRQ. Choosing Disable makes
serial port 1 unusable. If Auto is selected, Setup configures COM1 to
address = 3F8h and IRQ = 4.
Serial port 2
Auto
Disabled
3F8, IRQ 4
2F8, IRQ 3
3E8, IRQ 4
2E8, IRQ 3 Enables or disables onboard serial port 2 at the specified address.
Select Auto unless interrupts IRQ4 and/or IRQ3 are allocated as a
computer resource.
Two devices cannot share the same IRQ. Choosing Disable makes
serial port 2 unusable. If Auto is selected, Setup configures COM2 to
address = 2F8h and IRQ = 3.
Diskette
controller Enabled
Disabled Enables or disables the onboard diskette controller.
Exchange
diskette drives
Disabled
Enabled Logically exchanges physical diskette drive designations.
Diskette write
protection Disabled
Enabled Enables or disables the selected diskette drive’s write protect option.
IDE adapter 0
IDE adapter 1
Enabled
Disabled Enables or disables the onboard IDE 0/1 controller. Note that both
must be enabled for proper system operation.
Advanced Chipset Control
CAUTION
The following advanced chipset control options should normally stay at their default
values. Change them only if necessary to correct specific operating problems or errors.
Menu Fields Settings Comments
PCI Slot 1
Latency
Timer
Default
08h - F8h Select Default or a value from 08h to F8h to set the PCI device’s
latency timer. Default uses the PCI device’s power on setting.
PCI Slot 2
Latency
Timer Default
08h - F8h Select Default or a value from 08h to F8h to set the PCI device’s
latency timer. Default uses the PCI device’s power on setting.
VGA palette
snoop Enabled
Disabled
Default This option controls how VGA devices handle accesses to their palette
areas. Enabling this option causes special palette behavior (a device
must not respond to normal accesses). Disabling this option causes a
device to treat palette accesses like any other device access. Enable
VGA Palette Snoop when a second video adapter is connected to the
feature connector of the installed VGA adapter for multi-media
devices.